Brother PE-150 User Manual page 17

2
3
14
3. Guide the thread through the machine and the bobbin
winding guide as marked with the dotted line.
1
4. Guide the thread through the small hole in the side of the
bobbin from the inside. Holding the thread end, push the
bobbin winder shaft to right.
* Match the groove of the bobbin with the spring on the shaft.
1 Spring on the shaft
2 Groove in the bobbin
5. Holding the thread end, press the "START/STOP" button.
Wind the thread a few times around the bobbin and press
the "START/STOP" button again.
Trim the excess thread from the top of the bobbin after the
machine stops.
* It is important to trim the thread close to the spoolend.
6. Press the "START/STOP" button. The machine will stop
automatically when the bobbin is full. Press the
"START/STOP" button to stop at any time or when the
bobbin has stopped moving and the motor is still running.
1 "START/STOP" button
7. Push the bobbin shaft to the left. Remove the bobbin and
continue sewing.
8. Set the bobbin into the shuttle as shown on page 15.
It's a good idea to have several full bobbins on
hand before start your project.