1. Manuals
  2. Brands
  3. Innowater Manuals
  4. Water Filtration Systems
  5. SMC75
  6. User manual

Innowater SMC75 User Manual

Salt water chlorinator
Hide thumbs Also See for SMC75:
Table of Contents

Advertisement

Quick Links

Download this manual
salt water chlorinator
smc 75-150
user manual
Rev. 15-03-2017

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SMC75 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Innowater SMC75

Summary of Contents for Innowater SMC75

  • Page 1 salt water chlorinator smc 75-150 user manual Rev. 15-03-2017...

  • Page 2: Table Of Contents

    CONTENTS 1. Security warnings…………………………………… 3 2. Unit descrip on …………………………………. 4 3. Control and power panel installa on……...5 4. Cell installa on………………….……...…………… 5 Cell housing Electrode assembly Flow switch Celle leads 5. Pump commissioning………………………………6 6. Electrical connec ons.…………………………….7 6. Opera on………………………………………………..7 6.1 Screen indica ons 6.2 ON/OFF switching 6.3 ON state: produc on...

  • Page 3: Safety Warnings

    1. SAFETY WARNINGS • Before a emp ng the installa on or any manipula on on the unit make sure the it is disconnected from the power mains. • The unit should be connected to a proper protec ve earth conductor. •...

  • Page 4: Unit Descrip On

    2 . UNIT DESCRIPTION The SMC75 is an high performance electroly c chlorine generator. The unit produces pure chlorine, with- out any addi ves, directly from water with a salt concentra on above 4.0 gr/l. The chlorinator is installed in-line in the pool filtra on circuit. Part of the return water flow is forced through the cell by means of a by- pass placed at the end of the circuit, once the water has passed through the filter and through any other...

  • Page 5: Control And Power Panel Installa On

    3. CONTROL AND POWER PANEL INSTALLATION Install the unit in a fresh and well ven lated place. Mount the panel on the wall using the supports on its back. The panel should impera vely be mounted upright. Keep any acid tanks away from the room where the unit has been installed. Acid vapours a ack metals including stainless steal and destroy electronic circuits.

  • Page 6: Electrode Assembly

    In order to effec vely evacuate the gas generated, the water outlet must always be above the water inlet. If the cell is installed ver cally, the water must enter the cell through the bo om inlet. Do not install the cell before the filter or any other element. The chlorinator cell must be the last ele- ment the water passes through before returning to the pool.

  • Page 7: Electrical Connec Ons

    Before star ng the pump for the first me , open the central by-pass valve fully to avoid any over pressure in the cell housing. Once the pump is running, open the inlet and outlet valves slowly un l they are fully open. You can then par ally close the central valve in order to send the flow through the cell un l you have a rapid an uniform flow.
  • Page 8 6.1 Main Screen Readings ■■■■■■■■■■■■■■■■ 6.4A 23.5V 6.2A 23.9V Tint 34ºC Water — Cext OFF Flow EXT. Control OFF Descrip on: → Produc on state ■■■■■■■■■■■■■■■■ → Chlorine produc on se ng 6.4A 23.5V → Cell 1 working values 6.2A 23.9V →...

  • Page 9: Display Messages

    To control the chlorine produc on according to the pump running cycles or any other signal use the Exter- nal Control Cable as explained in sec on 5. DO NOT disconnect and reconnect the mains power supply ca- ble. When the unit is in OFF state the chlorine produc on is not allowed but you will s ll have access to the pro- duc on se ngs, menus and to all working parameters.

  • Page 10: Menus

    LOW SALT The es mated salt concentra on is lower than the op mum working range. The unit will remain in ON state and chlorine produc on will con nue normally. This message can also be displayed if the water is too cold, the electrodes are worn-out or calcium has built up on the electrodes.

  • Page 11: Regular Maintenance

    The electrodes of the SMC75 cell have been build using the most advanced technique in the market and with a very high quality control. However there are several situa ons that can reduce the performance and the life span of any electrode and you should avoid them: - Opera on with a low water level or flow in the cell...

  • Page 12: Warnings

    10. WARNINGS - NEVER power the unit without being connected to a protec ve earth conductor. - NEVER operate the chlorinator without an external 30 mA residual circuit breaker protec on. - NEVER operate the chlorinator if the pump is not running or if the flow through the cells is too low. The gas generated in the electroly c proceeds could break the cell and eventually explode.

This manual is also suitable for:

Smc150

Table of Contents