Lumascape Star II LS275A-2 Installation Instructions

Lumascape Lighting Industries Pty Ltd
38-44 Enterprise Street, Cleveland, QLD 4163, Australia
PO Box 1875, Cleveland D.C., QLD 4163, Australia
T 07 3286 2299
F 07 3286 6599
E sales@lumascape.com.au
W www.lumascape.com.au
LS275A-2: Star II
Warranty void if not installed as per installation instructions
DANGER
ISOLATE LUMINAIRE FROM POWER
Failure to isolate power
supply before installation or
maintenance may result in
fire, serious injury, electric
shock, death and may
damage the luminaire.
IMPORTANT: Submersed before lighting
1. Fit lamp as in re-lamping instructions (below and Fig. B).
2. Mount base plate using a suitable non-corrosive fastener. Two 6 mm
stainless steel dynabolts are recommended for concrete mounting.
3. Fit fixture to base plate locating the stud in the base plate slot and tighten
wingnut.
4. Run the cable out and connect to an isolating type transformer.
5. Do not loose joint the cable under water. All joints must be water tight.
6. Ensure that the supply voltage is 12 volts before switching on.
7. Aim fixture and tighten wing nut.
RELAMPING
1. Loosen wingnut and remove from base plate.
2. Lift the fitting from the water.
3. Remove the 4 stainless steel phillips head screws that retain the cover and
lift off.
4. Remove the stainless steel circlip in the cover that retains the lamp.
5. Pull the holder off the lamp pins.
6. Inspect the lamp pins for burning. If there appears to be burnt pins replace
the lamp holder using the LS275A-2 lamp holder replacement kit.
7. Fit the lamp holder onto the new lamp ensuring that it sits all the way on
the lamp pins.
8. Fit lamp holder onto the front cover and refit the stainless steel circlip into
its correct groove.
9. Inspect the seal and ensure that it is in good condition and correctly fitted.
10. Fit the cover to the body and fit all 4 stainless steel phillips head screws
and tighten.
11. Submerse in the water before lighting.
CAUTION: FITTINGS CAN BECOME
HOT. USE DISCRETION IN
PLACEMENT
PLEASE ENSURE THAT
INSTALLATION COMPLIES WITH
LOCAL AUTHORITY STANDARDS
www.lumascape.com.au
The luminaire should only be used complete with its protective
If cable is damaged replace with cable supplied
Do not shorten, interfere or disconnect cable from fitting.
Warranty will be void if cable assembly is tampered with.
Luminaire must be installed and operated underwater at all
Copyright ©2014 Lumascape Lighting Industries Pty. Ltd. ABN 21 010 572 773
INSTALLATION INSTRUCTIONS
WARNING
shield (cover)
by Lumascape only.
transformer
Figure A
wingnut
MODEL: LS275A-2
INPUT VOLTAGE: 12 V
times.
Ø 65 mm
power
outlet
stainless
steel screws
louvre
lid
lamp
lamp holder
LS275A-2 body
stainless steel
dynabolt
base plate
Figure B
UNDERWATER
A.C.N. 0105 72 773
o
180
IN0148 - 04 June 2014