Operation; Using The Control Panel; Using The Remote Control - HOMCOM M2117-32 Instruction Manual

OPERATION

After reading all the instructions, ensure the fireplace controls are in the OFF
position. Then, plug the fireplace into a 15A/120V outlet.

USING THE CONTROL PANEL

The controls are on the right side of the unit.
: Press this button to turn the fireplace on. Press it again to turn it off.
Once the fireplace is turned off, the fan will continue to operate for 60
seconds without heat.
: Press this button to change the flame color. There are ten different
flame effects available. Keep pressing the button until you reach the
desired color effect.
: Press the button to change the flame effect. Press it again to
decrease the flame intensity. There are six light intensities available,
numbered from 6-1. Press the button once more to stop the flame
effect.
: Press this button to set the temperature – press it repeatedly until
you reach the desired temperature. Once the desired ambient
temperature is reached, the heater will automatically stop heating.
Please note, if the ambient temperature drops 2°C below the desired
temperature, the heater will resume heating.

USING THE REMOTE CONTROL

NOTE: For optimal performance, use the remote control in front of the heater, ensuring you
do not exceed five meters from the heater.
1 CR2025 batteries required
(NOT INCLUDED)
5