Belkin F5D9231-4 User Manual page 44

UsInG THe Web-based adVanCed UseR InTeRfaCe
sections
table of contents
Using Wi-fi Protected setup
WPS uses WPA2 (described on page 44) for encryption� It does not
provide additional security, but rather, standardizes the method for
securing your wireless network� You may use either the Push Button
Configuration (PBC) method or PIN method to allow a device access to
your wireless network� Conceptually, the two methods work as follows:
PBC: Push and hold the WPS button located on the back of your Router
for three seconds� Then, initiate the WPS procedure on the client
device within two minutes� Refer to your client's documentation on this
procedure� Pushing the PBC button will automatically enable WPS� The
client has now been securely added to your wireless network�
G+ MIMO Wireless Router
1 2 3 4 5 6
PIN: The client device has a PIN number (either four or eight digits) that
is associated with WPS� Enable WPS through the screen illustrated
below� Enter the client's PIN into the Router's internal registrar
(accessed through this screen)� The client will be automatically enrolled
into your wireless network within two minutes�
42
7 8 9 10