Fujitsu PRIMERGY RX600 S2 Start Manual

nPRIMERGY RX600 S2 Manuals
Manuals for this server can be accessed from the section below of the PRIMERGY Document & Tool CD.
[CD-ROM Drive] :\MANUAL\INDEX.PDF
Manuals can be displayed using Acrobat
1
Checking the items
supplied
Check the contents in the package using
the "Contents List".
If any items are missing, contact an office listed
in the "Contact Information".
3
Installing internal options
If internal options have been purchased separately, install them before installing the Operating System.
In the following case, it is not required to install the internal options.
- Custom Made Service
n Point to note before installing internal
options
When installing internal options, perform operations after
reading the following manuals.
"Chapter 7 Installing Internal Options"
"PRIMERGY Server Books"/
"Supplement"
Install the OS before installing the following options.
Installing the OS after options have been installed will
cause installation operations to end in an error.
- Non-system hard disks
- External SCSI optional devices (DAT unit, Hard disk
cabinet, Backup cabinet, etc.)
RX600 S2
® Reader ® or Adobe ® Reader
1
® . If using Acrobat ® Reader ® , use version 4.0 or later.
2
Reading and understand-
ing "Safety Precautions"
Before using this server, be sure to read and un-
derstand the attached "Safety Precautions".
Also check it when connecting, installing internal options
and setting up this server.
n Available Internal options and
installation locations
���������
�������������
���������
��������������
After installing internal options, check that the order and
place of installation is correct and cables are correctly at-
tached.
B7FH-3741-01EN-00
��������������
�������
����������
����
���