Using The Product As Intended; Safety Notes; Important Notes; Contents - marklin Start up Bi-Level Cab Control Car Manual

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 9

1. Using the Product as Intended

This car may only be used with an operating system (Märklin
AC, Märklin Delta or Märklin Digital) designed for it.

2. Safety Notes

• This toy train set must never be supplied with power from
more than one power pack (max. 22V).
• This toy train set may only be used with a switched mode
power pack designed for toys.
• Use only switched mode power packs and transformers
that are designed for your local power system.
• The 66201 switched mode power pack or the 66471 trans-
former is suitable for this toy.
• The switched mode power pack is not a toy.
• Make sure you inspect the condition of the switched
power pack and its connections to the wall outlet for
damage at regular intervals (depending on how often the
switched power pack is used to play with the train), at
least once a week. This must be done with the switched
power pack unplugged from the wall outlet. If you have
the slightest suspicion that there is damage, the switched
power pack may not be used again until it has been
checked and repaired by the Märklin Repair Department).
• Pay close attention to the safety notes in the instructions
for your operating system.
• WARNING! Not suitable for children under 3 years. Sharp
edges and points required for operation. Danger of choking
due to detachable small parts that may be swallowed.
Misuse of the switched mode power pack can cause an
electrical shock.
• Do not expose the model to direct sunlight, extreme
changes in temperature, or high humidity.
• The LEDs in this item correspond to Laser Class 1 accor-
ding to Standard EN 60825-1.

2.1 Important Notes

• Installation and repairs should only be done by adults.
• Please see your authorized Märklin dealer for repairs or
spare parts.

3. Contents

1 x car
1 x Set of instructions for use

4. Functions

• The cab control car is equipped with a red marker light.
• This lighting functions will all track power systems using
3-rail operation. It is not intended for conversion to 2-rail
operation.
Märklin START UP can be added to and expanded with
Märklin H0 or Märklin Digital. See your authorized Märklin
dealer for advice.

5. Trouble Running

Headlights / marker lights do not work. Check the following:
• Are all the wheels for the car sitting on the rails properly?
• Is a connecting wire to the layout damaged? Replace the
damaged wire.
9

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Start up Bi-Level Cab Control Car and is the answer not in the manual?

This manual is also suitable for:

40402

Table of Contents