Related Manuals for LePRESSO LPCCAPBK
Summary of Contents for LePRESSO LPCCAPBK
- Page 1 USER MANUAL LPCCAPBK NESPRESSO CAPSULE COFFEE MACHINE MACHINE À CAFÉ À CAPSULES NESPRESSO...
-
Page 2: Table Of Contents
Espresso Co ee Mak er with Nespresso Capsule properly it will reward you with many years of good service. Content – Unpacking – Capsule type can be used – Overview of machine parts and controls – Fill/refill water – Flushing out the machine/internal piping/first use –... -
Page 4: Unpacking
and pass it on to the next user. manual, please contact the service and sales centre. Unpacking − Remove your espresso capsule co ee machine from its packaging 1. Water tank 2. Co ee machine 3. Manual Note: Tip: Note: In order to ensure that this machine works perfectly, it was tested with water before leaving the factory. -
Page 5: Overview Of Machine Parts And Controls
Overview of machine parts and controls Lungo Normal Espresso button espresso button No. Name Handle Bu ons Dispenser Drip tray set Wall Water tank cover Water tank (removable) Power cord Main switch Used Capsule Container Drip Tray Cover Drip Tray(removable) -
Page 6: Fill/Refill Water
Wait for ready Ready Light steady Light steady when Fill/re water. There are two ways to fill the water tank: directly into the machine, by using for ex g, or by removing the water tank. Filling without removing the tank –... -
Page 7: Flushing Out The Machine/Internal Piping/First Use
Filling by removing the water tank –Fill the tank up to the “MAX” mark with cold fresh water (the maximum capacity is 0.8 litre). or at least the “Min” mark . – Slide the water tank slowly on water tank base, when the water tank outlet is inserted in the inlet receptacle, to lock the water tank . - Page 8 – The handle is closed without capsule inside. – The water tank is full. – The water tank is in place before brewing. Because there is hot cleaning scalding! – The drip tray with the used capsule container is completely inserted (never operate the machine without drip tray set (part D shown in “Overview of machine parts and controls”), or hot water will run out when opening handle.
-
Page 9: Brewing Coffee
Brewing coffee *Make sure the water tank is in place before brewing. Because there is hot cleaning water – Place an empty cup under the dispenser. For small cups, low down the dispensing spout. 1. Move the handle back completely. 2. -
Page 10: Programming The Coffee Volume
AUTION: Beware of hot st ger of sc ht turns fr red t Programming the coffee volume. Be sure there is enough water in the t efore progr co ee v under the dispenser. F ow down the dispensing spout. etel . -
Page 11: Cleaning
Cleaning Emptying the capsule container and drip tray The capsule container holds around 10 used capsules. We recommend emptying the used capsule container and the drip tray every day, you can see if the used capsule container is full or not while the blue light is on in the used capsule container. -
Page 14: Technical Data
Fill water in the water tank. The water tank is empty. No coffee is brewed. The coffee is not hot -the Cold cups / mugs. Preheat cup / mug. - Descale. enough. - Scale build-up in machine. - For cold machine, brewing a cup of water to warm up the circuit.
Need help?
Do you have a question about the LPCCAPBK and is the answer not in the manual?
Questions and answers