Under no circumstances should solid ice functioning of the appliance and the relevant be forced off the liner. Solid ice should be allowed warnings. to thaw when defrosting the appliance. See defrost instructions.
For building into kitchen units follow the special Fig. 1. “Building-in” instructions given. A t t e n t i o n : k e e p ventilation open- min. Electrical connection ings clear of ob- struction.
To ensure correct storage of food, the door is fitted PR33 u n i t d o o r u s i n g with a simple spring device which holds it in the open 3.5x16 mm screws.
To remove this holder, lift the back of the shelf (glass), frost to form on the rear wall. In this case the dial press and pull it out (see fig.). Slide the holder out and must be set to a higher temperature to allow auto- refit the shelf (glass).
Positioning the door shelves it is advisable to show the freezing-in date on each in- dividual pack to enable you to keep tab of the storage To permit storage of food packages of various sizes, time; the door shelves can be adjusted in height.
Defrosting leave the door open, place a basin on the top shelf of the refrigerator compartment, under the drain hole, re- Frost is automatically eliminated from the evaporator move the plug as shown in the figure; of the refrigerator compartment every time the motor Fig.
Need help?
Do you have a question about the JKI 4453 and is the answer not in the manual?
Questions and answers