Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for JUNO JKG1463
Summary of Contents for JUNO JKG1463
- Page 1 JKG 1463 GEBRAUCHSANWEISUNG OPERATING INSTRUCTIONS 2222 147-25...
-
Page 2: General Safety
If this appliance featuring magnetic door seals is to replace an older appliance having a spring lock (latch) on the door or lid, be sure to make that spring lock unusable before you discard the old appliance. This will prevent it from becoming a death-trap for a child. -
Page 3: Environment Protection
Use - Cleaning the interior - Operation - Temperature regulation - Fresh food refrigeration - Freezing . fresh food - Storage of frozen food - Thawing - Ice-cube production ......14 Use - Movable shelves - Door shelves - Hints - Hints for refrigeration - Hints for freezing . - Page 4 In this case the dial must be set to a higher Small pieces may even be cooked still frozen, directly temperature to allow automatic defrosting and from the freezer: in this case, cooking will take longer.
- Page 5 Meat (all types): wrap in polythene bags and place on the glass shelf above the vegetable drawer. Hints for freezing For safety, store in this way only one or two days at the most. To help you make the most of the freezing process, here are some important hints: Cooked foods, cold dishes, etc..: these should be...
-
Page 6: Maintenance
- unscrew the light cover securing screw. - unhook the moving part as shown in the figure. If the light does not come on when the door is open, check that it is screwed into place properly. If it still does not light up, change the bulb. -
Page 7: Customer Service And Spare Parts
To carry out complete defrosting of the freezer compartment proceed as follows: D068 1. pull out the plug from the wall socket or turn the thermostat knob to the ÇOÈ setting; 2. remove any stored food, wrap it in several layers Important: of newspaper and put it in a cool place;... -
Page 8: Installation
Left opening Remove the pins (P) and (P1) Remove (P) from both sides and the door. Remove the middle hinge (A) and refit it on the opposite side. Refit the door and (P) on the left side. Remove (P1) from the right side. - Page 9 D567 For safety reasons, minimum ventilation must be as shown in Fig. Attention: keep ventilation openings clear of obstruction. It is necessary that the niche is provided with a conduct of ventilation having the following dimensions: Depth 50 mm Width...
- Page 10 Apply covers (B) on joint cover lugs and into hinge holes. D726 Separate parts A, B, C, D as shown in the figure PR266 Place guide (A) on the inside part of the furniture door, up and down as shown in the figure and mark the position of external holes.
- Page 11 Remove the squares and drill holes with ¿ 2 mm at 8 mm from the outer edge of the door. Place the small square on the guide again and fix it with the screws supplied.