“ Frozen food must not be re-frozen once it has been thawed out. “ Manufacturers’ storage recommendations should be strictly adhered to. Refer to relevant instructions.
(latch) ply, make sure that the voltage and frequency shown on the door or lid, be sure to make that spring lock un- on the rating plate correspond to your home supply.
560 mm Remove pins (A) and (C) from both sides and the door. Remove the middle hinge and refit it on the opposite side. Refit the door and pin (A) on the left side. Remove pin (D) from the right side.
After preparing the unit, fit the trimming h o l e s , s c re w t h e provided together D094 runners to the kit- with the appliance on chen unit door using 3.5x16 mm screws.
Page 7
(3.5x16 mm). For the alignment of the kitchen unit PR35 door, if necessary, use the clearance size of the slotted holes. At the end of the procedure, check that the doors of the appliance and the kitchen unit open properly.
Movable wire shelves To achieve the best results with the refrigerator com- The walls of the refrigerator are equipped with a series partment, you should follow one or two very simple of runners so that the shelves can be positioned as rules: desired (Fig.
Keep the freezer door open and introduce a container filled with hot water (taking care to place this on a lay- er of cardboard) so as to accelerate the defrosting process.
The light inside the refrigerator compartment is easy to get at through the opening in the light holder. Internal cleaning If the light does not go on when the door is open, check that it is screwed into place properly. Clean the interior periodically with lukewarm water and some bicarbonate of soda;...
Need help?
Do you have a question about the JKG1453 and is the answer not in the manual?
Questions and answers