Attention: keep ventilation openings clear of heat exchanger. Information on your local o b s t r u c t i o n . disposal sites may be obtained from your municipal authorities.
(latch) ply, make sure that the voltage and frequency shown on the door or lid, be sure to make that spring lock un- on the rating plate correspond to your home supply.
Remove the middle hinge and refit it on the opposite side. Fig. 2 50-min. cm 200 Refit the door and pin (A) on the left side. Remove pin For appropriate vent- (D) from the right side. ing, follow indica- tions in Fig. 2.
Page 6
fit the trimming holes. provided together After preparing the with the appliance on h o l e s , s c re w t h e D265 D094 the stop strip (A). runners to the kit- chen unit door using 3.5x16 mm screws.
To make these adjustments proceed as follows: do cover or wrap the food, particularly if it has a Gradually pull the shelf in the direction of the arrows strong flavour.
Keep the freezer door open and introduce a container filled with hot water (taking care to place this on a lay- er of cardboard) so as to accelerate the defrosting process.