Under no circumstances should solid ice functioning of the appliance and the relevant be forced off the liner. Solid ice should be allowed warnings. to thaw when defrosting the appliance. See defrost instructions.
(latch) ply, make sure that the voltage and frequency shown on the door or lid, be sure to make that spring lock un- on the rating plate correspond to your home supply.
560 mm Remove pins (A) and (C) from both sides and the door. Remove the middle hinge and refit it on the opposite side. Refit the door and pin (A) on the left side. Remove pin (D) from the right side.
After preparing the unit, fit the trimming h o l e s , s c re w t h e provided together D094 runners to the kit- with the appliance on chen unit door using 3.5x16 mm screws.
Page 7
(3.5x16 mm). For the alignment of the kitchen unit PR35 door, if necessary, use the clearance size of the slotted holes. At the end of the procedure, check that the doors of the appliance and the kitchen unit open properly.
To make these adjustments proceed as follows: do cover or wrap the food, particularly if it has a Gradually pull the shelf in the direction of the arrows strong flavour.
Keep the freezer door open and introduce a container filled with hot water (taking care to place this on a lay- er of cardboard) so as to accelerate the defrosting process.
figure. with a Silicone wax spray; the condenser and the mo- If the door is open and the light does not come on, tor compressor with a brush or a vacuum cleaner. check that the bulb is properly screwed in; if it still...
Need help?
Do you have a question about the JKG1454 and is the answer not in the manual?
Questions and answers