Important Safety Instructions; Read And Follow All Instructions; Installation - Hayward GOLD LINE CONTROLS Aqua Logic Aqua Pod PRO LOGIC Operation Manual

IMPORTANT SAFETY INSTRUCTIONS

When using this electrical equipment, basic safety precau-
tions should always be followed, including the following:

READ AND FOLLOW ALL INSTRUCTIONS

•
•
Warning - To reduce the risk of injury, do not permit
children to use this product unless they are closely
supervised at all times.
•
Dry Handheld unit before charging.
•
Do not allow charging base to come in contact with water.
SAVE THESE INSTRUCTIONS
•
ompatibility
C
This Aqua Pod handheld remote control is compatible with all Pro Logic controls
using an AQL2-BASE-RF base station.
The Aqua Pod is also compatible with all Aqua Logic controls operating with software
revision r2.60 or higher using an AQL2-BASE-RF base station operating with soft-
ware revision r3.00 or higher. Note that the Aqua Pod will NOT communicate with a
AQL-BASE-RF base station. To verify the software level of your Aqua Logic control
and base station, press the Menu button (possibly multiple times) until "Diagnostic
Menu" is displayed. Press the ">" or "<" keys (possibly multiple times) until the main
software revision level is displayed (the revision should be 2.60 or higher). Next,
press the ">" key (possibly multiple times) until the "RF Base" revision level is shown
(the revision should be 3.00 or higher).

Installation

The Aqua Pod uses a rechargeable built-in battery pack which will require an initial
charge when you first receive the unit. Charge the Aqua Pod for at least 5 hours
before attempting to use it without the charger. Note that the Aqua Pod can be used
normally while connected to the charger. Installation of the Aqua Pod requires that
you follow the steps below.
1. Battery is installed at the factory: Do not attempt to open the Aqua Pod.
2. Base Station required: For operation of the Aqua Pod, the Pro Logic or Aqua
Logic control must have a base station (AQL2-BASE-RF) installed. The base
station allows the control unit to communicate with the Aqua Pod remote.
3. Teach the unique Pro Logic/Aqua Logic ID code: The base station attached to
the control has a unique ID code that ensures that your unit will not affect other
systems in the neighborhood, and likewise, their remotes will not affect your
system. To teach the ID code to the Aqua Pod remote unit:
Installation
1