Regular Maintenance; Filling The Steam Tank - Fagor FTD800 Installation And Operating Instructions Manual

5 / PROGRAMMING
• "Additional Drying" option :
This option is not available for Steam pro-
grams
This function enables you to add drying time
at the end of a program in units of 10 minutes
by successively pressing the "Additional
Drying" button D D . Press the "Start/Pause"
button. The additional drying time is added at
the end of the selected program.
• " MEMO ACTIV' " function :
Your dryer remembers the programs that you
use most often.
After a few drying cycles, the program displayed
when you switch on your machine is the one
that you have used most often.
Important :
A power failure cancels the current program. In this case, therefore, you have to reset all
the programming operations.
Advice :
As a safety measure, you are advised to unplug the power cable when you are not using
the appliance.
Additional time
Pause Stop
18

6 / REGULAR MAINTENANCE

• FILLING THE STEAM TANK

+
The 1.2 litre steam tank contains enough water to last approximately three cycles.
-
It is equipped with a filter that recovers the impurities found in the water. Properly filtered water is
necessary for smooth functioning of the steam generator.
Important :
We remind you that the tank must be fil-
led before the "Steam" program is used for
the first time.
Important :
Only fill the Steam tank with distilled
water or fully demineralised water. Do not
use tap water or water containing any additi-
ves. The water from the recovery tank can
also be used provided that it has been filte-
red using the filter provided for this purpose
on the steam tank inlet.
To fill the tank, proceed as follows :
— Press on the upper part of the tank to free it
from its housing (Fig. 06).
— Fill the tank ( Fig. 07) .
— Press on the upper part of the tank to re-
seat it in its housing.
You can also use the water from the recovery
tank :
— Remove the water recovery tank (see fig. 20
on the next page).
— Extract the channeling tube from the water
recovery tank ( Fig. 08).
— Fill the tank ( Fig. 09).
— Press on the upper part of the tank to re-
seat it in its housing.
Important :
If you use water from the recovery tank,
regularly clean the tank filter by pulling pills
away with your fingers (Fig. 10).
Fig. 06
Fig. 07
Fig. 08
Fig. 09
Fig. 10
19