Fagor FAS 3612 Manual page 7

2
WATER AND DRAINAGE CONNNECTION
The water supply hose is inside the drum:
a Connect the bent end of the hose to the
threaded inlet located on the back of
the washing machine.
b Connect the other end of the hose to
the water intake. Then securely tighten
the connection nut.
It is important that the drain hose is
correctly fastened to the outlet, to
prevent any risk of it becoming
detached and causing flooding.
If your washing machine has a hot
water intake, connect the hose with
the red threaded end to the hot water
tap, and to the electrovalve with the
red filter.
The machine must be connected to
the mains water supply, using the
new hoses supplied with the
appliance. Do not use water supply
hoses that have been used before.
For your washing machine to work
properly, the water pressure-must be
between 0.05 and 1MPa (0.05 and 10
2
Kgr/cm ).
a It is recommended that you have a fixed
drainage outlet 20-28 inches from the
floor.
Make sure there are no kinks or bends
in the hose.
WATER
CONNECTION
DRAINAGE
CONNECTION
installation and assembly
a
28''
7
20''