Setting The Clock - Aiwa XR-M75 Operating Instructions Manual

USING THE REMOTE CONTROL SETTING THE CLOCK
Inserting batteries
Detach the battery cover on the rear of the remote control and
insert two R03 (size AAA) batteries.
.;'0;8
&>" yo&
1</
q,
e
'""""'"
Q
o
R03 (AAA)
When to replace the batteries
The maximum operational distance between the remote control
and the sensor on the CD player unit should be approximately 5
meters (16 feet). When this distance decreases, replace the
batteries with new ones.
Opening and closing the top cover
When to use the remote control
Some operations can be performed using the buttons on the
remote control only, while others can be performed using the
buttons on the two main units as well as on the remote control.
This instructions manual clearly describes the buttons available
for each operation.
m
If the unit is not going to be used for an extended period of
time, remove the batteries to prevent possible electrolyte
leakage.
The remote control may not operate correctly when:
- The line of sight between the remote control and the remote
sensor (see the illustration on the previous page) is exposed
to intense light, such as direct sunlight.
- Other remote controls are used nearby (television, etc.)
w
————-
CJLJL.JU
00
c1
–= i
~aa
Oo(joo"
{'l._ ..__. ._
–-J
SHIFT
To use the SHIFT button
Buttons O have two different functions. One of the functions is
indicated on the button, and the other on the plate above the
button.
To use the function on the button, simply press the button.
To use the function on the plate above the button, press the
button while pressing the SHIFT button.
1
2
3
4
5
6
7
00
0
00
POWER
Press the POWER button to turn on the power.
Press the CLOCK button while pressing the
SHIFT button on the remote control.
Within 4 seconds, press the I ~ button.
The hour flashes,
To restore the 12-hour standard, p~ess the button again.
Press the <+ or b+ button to designate the
hour.
Press the 11 button to set the hour.
The hour stops flashing and the minute starts flashing.
Press the ++ or B+ button to designate the
minute.
Press the II button to set the minute and
complete the setting.
The minute stops flashing on the display and the clock starts
from 00 seconds,
To display the current time
Press the CLOCK button while pressing the SHIF:T button on
the remote control. The time is displayed for 4 seconds.
If the clock display flashes while the power is off
This is caused by a power interruption. The current time needs
to be reset.
If power is interrupted for more than approximately 12 hours, all
settings stored in memory after purchase need to Ibe reset.
ENGLISH
7