Aiwa AV-DV70 Operating Instructions Manual page 20

ON SCREEN DISPLAY
SETTING THE SLEEP TIMER
The receiver provides an "On
Screen Display" function to show
the receiver settings on the TV screen. With the TV turned on,
when you operate the receiver buttons or remote control buttons,
the settings appear on the TV screen as well as the receiver
display. The following are examples of the "On Screen Display."
When turning on the receiver, pressing the function
buttons, or tuning in a station
On the right side of the
screen, the setting results appear for 5
MdN VIDEO 1
AUJOFM
TAPE OFF
{
MUT;;G
L
TUNER FREQ
87,50 MHz
VOL 10
"MUTING ON" continues flashing
until MUTING mode is set to off.
When m'essina audio effect buttons
such
as DOLBY
SURROUND, &P, GEQ, T-BASS, BBE and MANUAL
SELECT
On the left side of the screen, the audio effect settings appear
for 5 seconds.
PRO LOGICO:;F
DSP
L LVL MAX
R LVL MAX
GEQ OFF
T-BASS
OFF
BBE OFF
When pressing CLOCK or SLEEP buttons on the remote
controi
On the left side of the
screen, the timer setting and the present
time appear for 5 seconds.
The receiver provides an "On Screen Display" function only when
the TV is connected to the MONITOR VIDEO OUT jack.
UPA, ~OWN7
2
1
The receiver can be automatically turned off at a specified time.
1 Press the AIWA RECEIVER button.
2
Press the SLEEP button.
The unit will be turned off after about 60 minutes.
To
specify the time until
the power is turned off
Press the UPA or DOWNV button on the main unit repeatedly
within four seconds after step 2.
Each time the button is pressed, the time changes between 5
and 240 minutes in 5-minute steps.
Specified time
To
check the time remaining until the power is turned off
Press the SLEEP button once. The remaining time is displayed
for four seconds.
To cancei the
sleep timer
Press the SLEEP button twice so that "SLEEP on the display
disappears.
m
The UP- or DOWNW button on the remote control cannot
be used to specify the time until the power is turned off. Use the
buttons on the main unit.
19
ENGLISH