150
Cannot connect to a server
•
Make sure the network cable is securely attached to the correct
connector at the system rear panel.
•
Try a different network cable.
•
Make sure you are using the correct and the current drivers.
•
Make sure the driver is loaded and the protocls are bound.
No video but LED on the front panel indicates system is in reset mode
•
Make sure the VRMs are plugged in and the pins are not bent.
•
Replace the failed VRM.
Problems with the network
Network status indicator does not light.
Do the following:
•
Check the cabling and network equipment to make sure that all
cables are properly connected.
•
Reinstall the network drivers.
•
Try another port or hub on the switch.
Diagnostics pass but the connection fails.
•
Make sure the network cable is securely attached.
•
Make sure you specify the correct frame type in the NET.CFG file.
The controller stopped working when an adapter was installed.
•
Make sure the cable is connected to the port from the onboard
network controller.
•
Make sure the other adapter supports shared interrupts and your
OS supports shared interrupts.
•
Try reseating the adapter.
5 Troubleshooting