5
Open the battery holder by pinching the top and bottom covers of
the holder (A), then detach the cable inside the battery pack (B).
6
Observe the post-installation instructions described on page 38.
Installing the RAID BBU
1
Observe the ESD precautions and pre-installation instructions
described on page 37.
2
If a memory board is installed in memory board slot D connector,
remove the board. For instructions on removing a memory board,
see page 75.
3
Open the battery holder by pinching the top and bottom covers of
the holder (A).
4
Connect the cable inside the battery pack (B).
5
Secure the battery cable to its chassis holder.
99