Inserting An Sd Card And Usb Memory - 3M X62w Product Safety Manual

Inserting an SD Card and USB Memory

When using the projector with a wireless LAN please insert the included Wireless Network Card.
When using a commercial SD Memory card in order to view images insert the SD Memory card in
the same manner.
And when using a commercial USB MEMORY in order to view images insert the USB MEMORY
to the AUX I/O port.
See User's Manual - Network Function for information on using either type of card.
1. Make sure the projector's power switch is OFF.
2. Remove the SD card slot cover.
 Lift the cover slightly by the small indentation in the
middle of the front of the cover using a finger nail or
other means.
 Pull the cover forward and remove it completely from
the projector.
3. Insert the SD card.
Slowly insert the SD card completely into the SD card
slot.
Make sure the angled corner of the SD card is facing
the right side (AUX I/O port side) of the projector while
inserting.
4. Replace the SD card slot cover.
Replace the cover by reversing the procedure used
when removing the cover.
Important Note:
To comply with FCC RF exposure compliance requirements, the antenna used for this
transmitter must be installed to provide a separation distance of at least 20cm from all
persons and must not be co-located or operating in conjunction with any other antenna or
transmitter.
1 3M™ Multimedia Projector X62w Product Safety Guide
Indentation
AUX I/� Port
SD Card Slot
Angled corner
© 3M 2006