Connecting Power; Network Connections - D-Link DES-802 User Manual

Connecting Power

Power is supplied to the 10/100 Fast Ethernet Switch through an AC power
cord. The AC power input voltage ranges from 100 to 240 VAC. A power
cable is included with the device.
Figure 6 : Connecting Power
Since the 10/100 Fast Ethernet Switch does not include a power switch,
plugging it in to a power outlet will immediately power it on.

Network Connections

If either port on the 10/100 Fast Ethernet Switch is set for full-duplex
operation, the device (or LAN) connected to that port should also be set for
full-duplex operation. The following sections discuss the requirements for
each operating mode.
12 Installation