Related Manuals for SCHUNK MMS 22-IOL
Summary of Contents for SCHUNK MMS 22-IOL
- Page 1 Assembly and Operating Manual MMS 22-IOL Magnetic Switch with IO-Link Interface Translation of Original Operating Manual...
- Page 2 Imprint Imprint Copyright: This manual is protected by copyright. The author is SCHUNK SE & Co. KG. All rights reserved. Technical changes: We reserve the right to make alterations for the purpose of technical improvement. Document number: 1598377 Version: 01.00 | 07/08/2024 | en...
-
Page 3: Table Of Contents
Declaration of conformity ............... 15 7 UKCA Declaration of Conformity ..............16 8 Information on the RoHS Directive, REACH Regulation and Substances of Very High Concern (SVHC) ..................17 01.00 | MMS 22-IOL | Assembly and Operating Manual | en | 1598377... -
Page 4: General
If the product is used as intended, the warranty is valid for 24 months from the ex-works delivery date under the following conditions: Observe the applicable documents, } 1.1.1 [/ 4] Observe the ambient conditions and operating conditions, } 2.3 [/ 5] 01.00 | MMS 22-IOL | Assembly and Operating Manual | en | 1598377... -
Page 5: Basic Safety Notes
Modifications, changes or reworking, e.g. additional threads, holes, or safety devices, can damage the product or impair its functionality or safety. Structural changes should only be made with the written approval of SCHUNK. 01.00 | MMS 22-IOL | Assembly and Operating Manual | en | 1598377... -
Page 6: Personnel Qualification
Before working with the product, the personnel must have read and understood the complete assembly and operating manual. Observe the national safety regulations and rules and general safety instructions. 01.00 | MMS 22-IOL | Assembly and Operating Manual | en | 1598377... -
Page 7: Technical Data
Communication interface IO-Link Specification: V1.1 Transmission rate COM 2 Port Class A More technical data is included in the catalog data sheet. Whichever is the latest version. 01.00 | MMS 22-IOL | Assembly and Operating Manual | en | 1598377... -
Page 8: Information About The Software
4 Information about the software To operate the sensor with IO-Link, an IO-Link master and corresponding software are required. The IODD required for operation can be downloaded from schunk.com or ioddfinder.io-link.com. 01.00 | MMS 22-IOL | Assembly and Operating Manual | en | 1598377... -
Page 9: Assembly And Settings
First, install the module on the adapter plate. Then teach in sensor. The sensor is an electronic component that can be sensitive to high-frequency interference or electromagnetic fields. 01.00 | MMS 22-IOL | Assembly and Operating Manual | en | 1598377... -
Page 10: Adjusting The Sensor
SCHUNK products. To do so, the exact limits must be taught in. This can be done with a teach-in tool (sensor in SIO mode) or by the software (sensor in IO-Link mode via IO-Link master). 01.00 | MMS 22-IOL | Assembly and Operating Manual | en | 1598377... - Page 11 ð After 5 seconds, the LED flashes at 1 Hz (50% duty cycle). ð Sensor Command Reply: [1] Teaching started is displayed. Within 12 seconds, move module to end position 2. 01.00 | MMS 22-IOL | Assembly and Operating Manual | en | 1598377...
-
Page 12: Sio Mode
Pull the sensor (1) back again slowly until it switches (LED lights up). Tighten the set-screw (4) to clamp the sensor (1) in this position in the groove (2). Test the switching position. 01.00 | MMS 22-IOL | Assembly and Operating Manual | en | 1598377... -
Page 13: Troubleshooting
10 mm. NOTE If these steps do not eliminate the problem, contact SCHUNK Service for troubleshooting. 01.00 | MMS 22-IOL | Assembly and Operating Manual | en | 1598377... -
Page 14: In Io-Link Mode
Check whether the LED lights up at the position to be sensed and that the sensor is operating. NOTE If the LED does not light up or the sensor is not operating, contact SCHUNK Service. 01.00 | MMS 22-IOL | Assembly and Operating Manual | en | 1598377... -
Page 15: Declaration Of Conformity
Proximity switches (IEC 60947-5-2:2007 + A1:2012) Signed for and on behalf of: SCHUNK SE & Co. KG Lauffen/Neckar, August 2024 i.V. Nico Peper; Director Software and Electronics; Technology & Innovation 01.00 | MMS 22-IOL | Assembly and Operating Manual | en | 1598377... -
Page 16: Ukca Declaration Of Conformity
Marcel Machado, address: refer to manufacturer's address Signed for and on behalf of: SCHUNK SE & Co. KG Lauffen/Neckar, August 2024 i.V. Nico Peper; Director Software and Electronics;Technology & Innovation 01.00 | MMS 22-IOL | Assembly and Operating Manual | en | 1598377... -
Page 17: Information On The Rohs Directive, Reach Regulation And Substances Of Very High Concern (Svhc)
"on the restriction of the use of certain hazardous substances in electrical and electronic equipment (RoHS)", or fulfill their intended function only as part of one. Therefore products from SCHUNK do not fall within the scope of the directive at this time. REACH Regulation Products from SCHUNK fully comply with the regulations of Regulation (EC) No. 1907/2006... - Page 18 01.00 | MMS 22-IOL | Assembly and Operating Manual | en | 1598377...
- Page 19 01.00 | MMS 22-IOL | Assembly and Operating Manual | en | 1598377...
- Page 20 SCHUNK SE & Co. KG Spanntechnik | Greiftechnik | Automatisierungstechnik Bahnhofstr. 106 - 134 D-74348 Lauffen/Neckar Tel. +49-7133-103-0 info@de.schunk.com schunk.com Folgen Sie uns I Follow us Wir drucken nachhaltig I We print sustainable...
Need help?
Do you have a question about the MMS 22-IOL and is the answer not in the manual?
Questions and answers