Advertisement
Installing the Stacking Kit (Fig.3)
• After removing the washer lid, lay the
stacking into position on top of the
washer.
• Secure the stacking kit with the screws
provided.
o 2 screws with star washers in the
rear (a)
o 4 screws without star washers on
top.
Dryer Grille Replacement (Fig. 4)
Fig.5
• While supporting the door, remove the hinge
screws.
Fig.4
• Place the door to the side.
• Remove the screw caps from the dryer grille.
• Remove the screws and grille.
• Place the provided grille into position and
secure with screws.
• Install the screw caps
Note
T1329C door panels must be trimmed when
installing a stacking kit.
Custom panels must be 231/4"L X 231/4"H,
when installing a stacking kit on a T1329C
dryer.
Trimming the Dryer Door Panel (Fig.5)
• Remove the trim frame from the dryer door.
• Using a fine bladed jigsaw, cut 1 13/16" from
the bottom of the door.
• Using a hack saw, shorten the side trim by
1 13/16"
• Install the trim on the door.
• Install the door.
a
Fig.3
Advertisement
