Related Manuals for Aqua Systems 9000 Series
Summary of Contents for Aqua Systems 9000 Series
- Page 1 Series 9000 Water Treatment System Owners Manual Installation Service & Parts Operation Guide The Clear Choice for Soft, Conditioned Water...
- Page 3 Valve Parts Diagram & List ----------------------------------------------------------------------- 6-16 Timer-Controlled Model-------------------------------------------------------------------------- 15-20 Meter-Controlled Model-------------------------------------------------------------------------- 21-27 Warranty Information ----------------------------------------------------------------------------------29 The Series 9000 Water Treatment Systems are designed and manufactured by: AQUA SYSTEMS 7785 East U.S. Highway 36 Phone: 317-272-3000 Avon, IN 46123 Fax: 317-272-5000...
-
Page 4: Pre Installation Review
Pre Installation Review Location Specifications: • Not intended to be used to treat water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. Hardness in grains:________________ Estimated Water Usage: __________ Iron in parts per million: ____________ Service Line Size: _______________ Notes: __________________________________________________________ Requirements for Proper Operation:... - Page 5 Installation Procedure • System and Installation must comply with state and local codes. Read all instructions before starting! A. Do you want your outside spigots on hard water? If so 1. Unpackage system and visually inspect. Note: If the system place provisions in the water line before enter- comes equipped with demand regeneration.
- Page 7 TIMER MODEL installation and start-up procedure...
- Page 8 METERED MODEL installation and start-up procedure...
- Page 9 Distributor System and Brine Tank Parts List for Main System and Brine Tank* Item No. Description Not Used Turbulator Distributor System Tank Shroud Brine Well Salt Shelf Resin Media Safety Shut Off - Brine Valve * In ordering these parts you must specify your model number.
-
Page 10: Maintenance Information
Maintenance Information Quick Disconnect Procedure: 1. Uplug unit from electrical power source. 6. Remove the two clips between the bypass and the control valve using a screwdriver or a 1/4” nut driver. 2. Move the Bypass lever from the “Service” position to Then gently slip the unit off of the bypass. - Page 11 TURBO DISTRIBUTOR water conditioner flow diagrams...
-
Page 13: Valve Body Assembly
VALVE BODY ASSEMBLY (see parts list) - Page 14 MODEL WCC VALVE BODY ASSEMBLY PARTS LIST...
-
Page 15: By-Pass Assembly
BY-PASS ASSEMBLY... - Page 16 METERED MODEL meter assembly...
- Page 17 TIMER MODEL control valve drive assembly (see opposite page for parts list)
- Page 18 TIMER MODEL CONTROL VALVE DRIVE ASSEMBLY PARTS LIST...
- Page 19 TIMER MODEL service instructions...
- Page 21 TIMER MODEL service instructions...
- Page 23 METERED MODEL control valve drive assembly (see opposite page for parts list)
- Page 24 METERED MODEL METER INITIATED PARTS LIST...
- Page 25 METERED MODEL service instructions...
- Page 26 METERED MODEL service instructions...
- Page 28 METERED MODEL service instructions...
-
Page 31: Limited Lifetime Warranty
This warranty applies to the original owner at the original location. This warranty is transferable to subsequent owners or locations only with prior written consent by AQUA SYSTEMS. Prior to written consent on transferring this warranty the system may require inspection by a service technician from AQUA SYSTEMS or one certified by AQUA SYSTEMS.
Need help?
Do you have a question about the 9000 Series and is the answer not in the manual?
Questions and answers