Advertisement
Operating Instruction and safety manual
Residual risks
Even when the tool is used as prescribed it is not possible to eliminate all residual risk factors. The
following hazards may arise in connection with the tool's construction and design:
1. Damage to lungs if an effective dust mask is not worn.
2. Damage to hearing if effective hearing protection is not worn.
3.
Wear eye protection.
4. Wear safety glove, hand protection.
1
Low pressure spray gun 112
Air Powered Spray Gun
Low Pressure Spray Gun
Model No.: 112
. Read this Instruction Manual carefully and
understand it completely, basic precaution should be
strictly followed to prevent the damage to the tool
and injury to the operator. Retain this manual for
further reference. And you should pay more attention
to the Technical Data.
.
2014
www.aeroprotools.com
Advertisement
Table of Contents
Related Manuals for Aeropro 112
Summary of Contents for Aeropro 112
- Page 1 1. Damage to lungs if an effective dust mask is not worn. 2. Damage to hearing if effective hearing protection is not worn. Wear eye protection. 4. Wear safety glove, hand protection. 2014 Low pressure spray gun 112 www.aeroprotools.com...
-
Page 2: Technical Data
(see fig 2) 3. Fluid and solvent can be highly flammable or combustible. Use in well-ventilated spray booth and avoid any ignition sources, such as smoking, open flames and decrial hazard. (see fig 3) Low pressure spray gun 112 www.aeroprotools.com... -
Page 3: Instructions For Operation
7. Test the consistency of the material by making a few strokes on a cardboard target. If material still appears too thick, add a small amount of thinner. THIN WITH CARE! Do not exceed paint manufacturer’s thinning recommendations. Low pressure spray gun 112 www.aeroprotools.com... - Page 4 Two thin coats of paint will yield better results and have less chance of runs than one heavy layer. 6. Use a piece of cardboard as a shield to catch overspray at the edges of the work to protect other surfaces. Low pressure spray gun 112 www.aeroprotools.com...
-
Page 5: Maintenance
Storing When not using spray gun, turn the fluid adjustment knob counter-clockwise to open which will reduce spring tension on needle fluid tip. Spray gun MUST BE well cleaned and lightly lubricated. Low pressure spray gun 112 www.aeroprotools.com... -
Page 6: Troubleshooting
Will not spray 1. No pressure at gun 1. Check air lines 2. Fluid control not open enough 2. Open fluid control 3. Fluid too heavy 3. Thin fluid or change to pressure feed system. Low pressure spray gun 112 www.aeroprotools.com... - Page 7 Note: Please contact with us if customer need to know parts material . If you need spare parts of this model, pls feel free to contact us or the distributor where you bought this tool. Tks! Low pressure spray gun 112 www.aeroprotools.com...
Need help?
Do you have a question about the 112 and is the answer not in the manual?
Questions and answers