Proper Location; Assembly Instructions; Installing Your Water Dispenser - Haier WDQS015 - INSTALLATION REV 03-04 Installation Instructions Manual

English

Proper Location

• To ensure that your water dispenser works at the maximum efficiency it was
designed for, you should install it in a location where there is proper air
circulation and electrical connections.
• The following are the recommended clearances around the water dispenser.
Sides..........3/4" (19mm)
Back ..............2" (50mm)
• Do not install your water dispenser in any location that is not properly insulated
or heated because the unit is not designed to operate in temperature settings
below 55˚F / 13˚C.
Note: The built-in thermostat maintains the hot and cold temperatures
automatically. The hot water temperature will be between
176-203˚F / 80-95˚C and the cold water temperature will be between
36-50˚F / 2-10˚C during this operation.
• Select a suitable location for the unit on a hard even surface away from direct
sunlight and heat sources (e.g., radiators, baseboard heaters, cooking
appliances, etc.).
Note: Hot and cold water will not be instantly available as the unit will need
time to heat up and cool down the water.
CAUTION: DO NOT plug in the water dispenser until water

Assembly Instructions

Read carefully and understand all installation instructions
before installing the water dispenser.

Installing Your Water Dispenser

Follow the steps below to install the water dispenser.
1. Remove the cap from the water bottle first. Lift up the
water bottle and quickly place it into the water guard.
Make sure it is standing in an upright position. (The water bottle is not included.)
2. DO NOT plug in the water dispenser until you have checked that
water flows out of both the red and blue faucets when pressed.
Never turn on the water dispenser without water in it. Doing so
may cause the unit to catch fire or malfunction.
Note: To avoid spilling water on the floor, we recommend that you use
"Spill-Proof" bottles, which are available at any water distributor.
"Spill-Proof" bottles are easy to install since cap removal is not necessary.
Contact your local water distributor for more information.
3. Check that water flows out by pressing both the red and blue faucets one at a
time.
4. Plug the power cord into an 115Volt / 60Hz outlet.
5. To activate the water heater and cooler, turn ON the red and green switches on
the back of the unit. The hot & cold indicators in the front will be lit.
13
flows through both Hot and Cold water faucets.