Table of Contents
Advertisement
4.
Place the 10" extrusions 22.75" apart as shown below. The distance will vary
depending on your chassis (this dimension is valid for the ASR 4 and ASR 6)
Tighten hand tight if you have a different chassis, tighten fully otherwise.
5.
Assemble the integrated arm with
2X M8 X 20 socket screws and
2X M8 t-nuts. Tighten no more than
a turn. Repeat mirrored on the
second arm.
6.
Slide the arms on the outer slot of the 10" extrusions as shown. Place them
flush and tighten fully.
4
Advertisement
Table of Contents
Need help?
Do you have a question about the Advanced integrated triple monitor stand and is the answer not in the manual?