Troubleshooting - Build with Robots Breezy Smart Controller User Manual

Troubleshooting

PROBLEM
Controller displays
unexpected Unihertz or
Android screen
Controller will not properly
control a Breezy Blue
device
Controller shows "?" next
to each Breezy Blue on list
Flashlight on controller is
accidentally turned on
The controller displays boot
screens with unknown
language.
D001128 Rev A.4
POSSIBLE CAUSES
Controller has entered
factory or debug
mode
Bluetooth pairing is not
valid
Controller display is not
properly refreshing
Controller red side
button was pressed
and held for > 1
second.
Volume up and power
buttons were pressed
together during the
device's starting. The
English version of the
earlier screen is
attached below.
www.BuildWithRobots.com
SOLUTION
Hold power button for 5
seconds, then press
again to power on.
Press Repair
Connections button
from menu on scanning
screen
Press the back button
and re-open the
scanning screen
Press and hold
controller red side
button until light turns
off
Hold the power button
for 5 seconds, then
press again to power
on. Note: Selecting
clear eMMC will reset
the controller to factory
mode. Contact BWR if
clear eMMC was
accidentally pressed.
Page 23