Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for rako WK-EOS-6
Summary of Contents for rako WK-EOS-6
- Page 1 Instruction Manual WK-EOS-6 6 Button Wired Keypad 2024 Version 2.0.0...
- Page 2 Installation should only be carried out by a competent electrician. The WK-EOS-6 comes in two parts, the installation guide refers to the ‘Back’ as the part which has the cable connections, and the ‘Front’ which has a four-pin connector which contains all of the programming.
- Page 3 Prepare cable(s) in the backbox ready for Step 1 connection. Set the front section of the WK-EOS-6 aside, as this is not yet required. Strip 70mm from the CAT5/CAT6 cable. Ensure there is enough slack on the cable to make re-termination easier should it be required.
- Page 4 RAK-LINK within the system. No Term - Both Jumpers removed Used when the WK-EOS-6 is not at the end of line. This is usually identifiable by two cables being punched down to the WK-EOS-6. Term - Jumper fitted across 1+2 & 4+5 Used when the WK-EOS-6 is end of line in a daisy chain configuration.
- Page 5 - For fault finding, “STAR” configuration. Appendix 2 - Wiring Examples A2.1 Radial Wiring When the WK-EOS-6 is wired in a loop in/loop out arrangement, this is referred to as Radial Wiring, an example can be seen below: WK-EOS-6 Manual Version 2.0.0...
- Page 6 A2.2 Star Wiring When the WK-EOS-6 is wired in a system with a RAK-STAR, this is referred to as STAR wiring, an example can be seen below: Appendix 3 - Coverplates (WP-EOS-60-xx) To mount the WK-EOS-6 to the wall a WP-EOS-60-xx is required as shown above. This is available in a variety of finishes including:...
Need help?
Do you have a question about the WK-EOS-6 and is the answer not in the manual?
Questions and answers