Remote Control - Panasonic SCHC37 Owner's Manual

Stations cannot be selected.
Change the FM frequency step.
1 Press [RADIO] to select "FM".
2 Press and hold [RADIO] on the main unit.
After a few seconds the display changes to show the
current lowest frequency. Continue to hold the button
down. The lowest frequency changes and the step is
changed.
iPod/iPhone operations
Cannot charge or operate.
≥ Check that the iPod/iPhone is connected firmly. (
≥ The battery of the iPod/iPhone is depleted. Charge the
iPod/iPhone, and then operate again.
≥ When unexpected operation occurs while using the
iPod/iPhone, connect the iPod/iPhone again or try to
restart the iPod/iPhone.

Remote control

The remote control doesn't work properly.
≥ The remote control and this unit are using a different code.
( right, "REMOTE ")
Messages
The following messages or service numbers
may appear on the unit's display.
"--:--"
≥ You plugged the AC power supply cord in for the first
time or there was a power failure recently. Set the time
( 11).
"ADJUST CLOCK"
≥ Clock is not set. Adjust the clock accordingly.
"ADJUST TIMER"
≥ Play timer is not set. Adjust the play timer accordingly.
"AUTO OFF"
≥ The unit has been left unused for about 30 minutes and
will shut down in a minute. Press any button to cancel it.
"CANNOT SET"
≥ Select an audio source other than "VTUNER".
"CHECKING CONNECTION"
≥ The unit is checking the connected iPod/iPhone. If this
display keeps appearing, make sure that iPod/iPhone is
inserted correctly and try again (
"DIMMER"
≥ Appears 10 seconds after the volume is turned to "0".
"ERROR"
≥ Incorrect operation is performed. Read the instructions
"F61"
≥ There is a power supply problem. Consult the dealer.
"ILLEGAL OPEN"
≥ Sliding door is not in correct position. Turn the unit off
"IPOD OVER CURRENT ERROR"
8)
≥ The iPod/iPhone is drawing too much power. Remove
"NODEVICE"
≥ The iPod/iPhone device is not inserted correctly. Read
"NO DISC"
≥ Insert the disc to be played (
"NO PLAY"
≥ A CD that is not in CD-DA format is inserted. It cannot be
"NOT SUPPORTED"
≥ You have inserted an iPod/iPhone that cannot be played
≥ If the iPod/iPhone is compatible, turn it on before
"READING"
≥ The unit is checking the CD information. After this
"START ERROR"
≥ Check the iPhone/iPod touch.
"REMOTE " ("
≥ The remote control and this unit are using different
8).
and try again.
and on again. If this display appears again, consult the
dealer.
the iPod/iPhone and turn the unit off and on again.
the instructions and try again (
played.
( 4). Insert correctly and try again if iPod/iPhone is
compatible.
inserting it to this unit.
display has disappeared, start operating.
Visit the below website for more information:
http://radio.vtuner.com/panasonic/en/
" stands for a number.)
codes. Change the code on the remote control.
– When "REMOTE 1" is displayed, press and hold [OK]
and [4] for more than 4 seconds.
– When "REMOTE 2" is displayed, press and hold [OK]
and [3] for more than 4 seconds.
8).
8).
RQT9633
13