AutoMeter INVISION LCD DASH KIT Manual page 7

Tachometer Scaling: The standard scale is 0-10,000 RPM. You can adjust the tachometer scale to be 0-8,000 RPM if desired.
To adjust the scaling, enter the Main Menu. Scroll to Tachometer, and press Enter. Next, scroll to RPM and press Enter. Scroll to the
desired scale, and press Enter.
Once you have chosen the Tachometer Scaling, scroll up to Back, and press Enter. Then, scroll up to Back again and press Enter. Once
you are back at the Main Menu, scroll to Close and press Enter.
Speedometer Calibration: Speedometer calibration will be required for an accurate speedometer reading. You will need a 2 mile pre-
marked distance.
To calibrate the speedometer, enter the Main Menu, scroll to Speedometer and press Enter. Next, scroll to Speed Calibration, and press
Enter.
Drive to the beginning of your 2 mile distance (this could be at your driveway or elsewhere). Choose Start Calibration and press Enter. The
display will now show "Stop Calibration" (don't press Enter yet). Drive 2 miles and come to a stop. Press Enter on Stop Calibration.
You don't have to come to a complete stop when pressing Stop Calibration, but it helps to insure that you have a more accurate 2 mile
distance. The more accurate your 2 miles are, the more accurate your speedometer will be.
If the speed sender/sensor is functioning, and your calibration is successful, you can scroll up to Back and press Enter. Then, scroll up to
Back again and press Enter. Once you are back at the Main Menu, scroll to Close and press Enter.