AutoMeter INVISION LCD DASH KIT Manual page 11

The odometer can be set to match the mileage on your vehicle. This can only be done ONE time only, and must be done within the first 500
miles. After being set, or 500 miles have been accumulated, this option will disappear and it cannot be set again.
To set your odometer, enter the Main Menu, scroll to Speedometer, and push Enter. Scroll down to Set Odometer and press Enter. Scroll
down to the odometer digits. When you get to the digit that you want to change, press Enter, then scroll up or down with the Selector Knob
until you get to the desired number and press Enter.
Trip Odometer: The InVision
To choose which Trip Odometer is displayed, enter the Main menu, scroll to Speedometer, and press Enter. You can
choose which Trip is displayed and also reset (clear) either one. Scroll to the option you want to choose and press Enter.
To Exit, scroll up to Back, and press Enter. Once you are back at the Main Menu, scroll to Close and press Enter.
System: This displays the versions of firmware the unit is equipped with.
You have the option to choose either Imperial (Miles, MPH, °F and PSI) or Metric (Kilometers, KM/H, °C and BAR) units.
Units:
To change the units of measure, enter the Main Menu, scroll to Units and press Enter. Scroll to either Imperial or Metric and press
Enter. To exit, scroll up to Back, and press Enter. Once you are back at the Main Menu, scroll to Close and press Enter.
®
Digital Dash has the main odometer and two trip odometers. Both trips can be reset at any time by the user