Pottery Barn WHITNEY 2 DRAWER PEDESTAL Assembly Instruction

Pre – Assembly:

Please read all instructions carefully before beginning assembly.

For your safety and convenience, assembly by two persons or more is
recommended.

Save all
accidentally discarding small parts or hardware.

Take out four pieces bun feet placed inside the lower drawer.
Parts Included
A. Pedestal
B. Bun Feet
Assembly Step:
1. Carefully lay the Pedestal (A) upside down in a carpeted floor or a clean
protected work surface.
2. Insert the pre-mounted bolt into female insert of the base and turn the Bun
feet (B) clockwise until tight, do the same steps to the remaining Bun feet
as shown in Figure 1, then flip the case upright.
3. Pull out one by one the file drawer and put the file rod A (i) in the groove
of the two sides drawer and put the file rod B (ii), do the remaining steps
to the bottom drawer as shown in Figure 2.
Figure 1
Leveler
Note:
If the floor is uneven adjust the levelers located at the underside of the Bun feet, to do this
lift up the side that need to be elevated to provide access to the levelers, turn the leveler
until adequate contact with the floor.
Care Instructions:

For daily cleaning, dust with a dry soft cloth.

Always avoid the use of chemical and abrasive cleaners.
WHITNEY 2 DRAWER PEDESTAL
ASSEMBLY INSTRUCTION
packing materials
: 1 pc.
: 4 pcs.
B
A
thank you for your purchase
stores | catalog |
until assembly
Hardware Included
i. File Rod A
ii. File Rod B
Figure 2
File Rod B
Drawer AntiTip
www.potterybarn.com
1/1
is complete to
: 4 pcs
: 4 pcs
File Rod A
avoid