Install And Charge The Battery; Charge The Battery - VTech VG231 User Manual

2. Align and place the wall mount bracket
on the standard wall plate.
B
B B
B B
A
3. Align and place the telephone base on
the wall mount bracket. Slide it down
until it clicks securely in place.
B B
4. Connect the power adapter.

Install and charge the battery

Install the battery as shown below.
• Use only the battery provided.
• Charge the battery provided with this
product only in accordance with the
instructions and limitations specified in this
manual.
• If the handset will not be used for a long
time, disconnect and remove the battery to
prevent possible leakage.
6

Charge the battery

Place the handset in the telephone base
or the charger to charge.
16 hrs
Once you have installed the battery, the
handset LCD display indicates the battery
status (see the table below).
• For best performance, keep the handset in the
telephone base or charger when not in use.
• The battery is fully charged after 16 hours of
continuous charging.
If you place the handset in the telephone
•
base or the charger without plugging
in the battery, the screen displays
No battery.
Battery Battery status Action
indicators
The screen The battery Charge without
is blank, or has no charge interruption
shows Put in or very little (at least 30
charger and charge. The minutes).
flashes. handset
cannot be
used.
The screen The battery has Charge without
shows Low enough charge interruption
battery and to be used for (at least 30
flashes. a short time. minutes).
The screen The battery is To keep
shows charged. the battery
HANDSET X. charged,
place it in the
telephone
base or
charger when
not in use.
When it is fully charged, you can expect
the following performance:
Operation Operating time
While in handset use Seven hours
(talking*)
While in Three and a half
speakerphone mode hours
(talking*)
While not in use Five days
(standby**)
* Operating times vary depending on your actual
use and the age of the battery.
** Handset is not charging or in use.
7