Timer Operation; Test Operation - Haier HSU-12LEA13-M - annexe 3 Operation Manual

Operation
HEALTH Operation
(This function is unavailable on some models.)
CLOCK
SWING
SLEEP HEALTH
POWER/SOFT
LOCK RESET
The anion generator in the airconditioner can
anion effectively balance the
generate a lot of
quantity of position and anion in
also to kill bacteria and speed up the dust sediment
in the room and finally clean the air in the room.
Healthy Negative ions

TIMER Operation

Set Clock correctly before starting Timer operation
You can let unit start or stop automatically a following times:
Before you wake up in the morning, or get back from outside
or after you fall asleep at night.
MODE SET
FAN TIMER
SWING CLOCK
(3) TIMER ON-OFF
(This function is unavailable on some models.)
MODE SET MODE SET
TIMER
FAN TIMER FAN
SWING CLOCK SWING CLOCK
To cancel TIMER mode
Just press TIMER button several times untilTIMER mode disappears.
3
the air and
TIMER ON
(1)
MODE SET
MODE
FAN TIMER
FAN
CLOCK
SWING
SWING
TIMER OFF
(2)
MODE SET MODE SET
TIMER TIMER
FAN FAN
SWING CLOCK SWING CLOCK
MODE SET
MODE
TIMER
FAN
FAN
CLOCK
SWING
SWING
POWER/SOFT Operation
(1) POWER Operation
SWING CLOCK
SLEEP HEALTH
LOCK
(2) SOFT Operation
SWING
SLEEP HEALTH
LOCK
To cancel SOFT operation
Press POWER/SOFT button again ,POWER/SOFT disappears.
Emergency operation and test operation
Emergency Operation:
Use this operation only when the remote controller
is defective or lost.
When the emergency operation switch is
pressed,the" Pi "sound is heard once, which means
the start of this operation.
In this operation, the system automatically selects
the operation modes,cooling or fan or heat,according
to the room temperature.
Room
temperature
SET
ABOVE 23 C
O
TIMER
BELOW 23 C
O
CLOCK
(Cooling only uint）
Room temperature
BELOW 23
It is not possible to operate in dry mode.

Test operation:

Test operation switch is the same as emergency switch.
Use this switch in the test operation when the room
temperature is below 16
normal operation.
Continue to press the test operation
switch for more than 5 seconds. After
SET
you hear the "Pi" sound twice,release
TIMER
your finger from the switch: the cooling
CLOCK
operation starts with the air flow speed "Hi".
After 30 minutes, test operation ends automatically(Only for 22K,24K unit).
(This function is unavailable on some models.)
When you need rapid heating or cooling,
you can use this function.
In COOL mode, fan speed automatically
takes high speed of AUTO fan mode.
In HEAT mode, fan speed automatically
takes medial speed of AUTO fan mode.
POWER/SOFT
To cancel POWER operation
RESET
Press POWER/SOFT button twice ,POWER/SOFT disappears.
You can use this function when silence
is needed for rest or reading.
In SOFT operation mode, fan speed
automatically takes low speed of AUTO fan mode.
CLOCK
POWER/SOFT
RESET
Timer
Operation Designated
mode
mode temperature
NO
COOLING 26 C
AUTOMATIC
O
HEAT AUTOMATIC
NO
23 C
O
Operation Designated
mode temperature
FAN
C 26 C
O O
o
C, do not use it in the
Pi
Air flow
Timer
Air flow
mode
NO
AUTOMATIC
Pi Pi