Wan - D-Link DI-1162M User Manual

WAN

The parameters are described below:
Description – This is a user-defined, 32-character identifier used to name the WAN.
Modem Init String – This parameter is valid only for asynchronous connections. It is a user input AT
command string to initialize a modem or ISDN TA attached to the WAN interface. Please refer to your WAN
device's handbook for more information about using initialization command strings.
The default setting is for Hayes-compatible asynchronous modems and is AT&FS0=1X1, where:
AT–
&F–
S0=1– Sets the modem to auto-answer.
X1 –
Protocol – This is a protocol used to encapsulate IP messages over synchronous and asynchronous serial links.
The device being connected to must be using the same protocol for a connection to succeed. The five protocols
are described:
1. CISCO_HDLC – This is a serial line encapsulation method for transmitting datagrams over synchronous
serial point-to-point links.
2. SLIP – Serial Line Internet Protocol. A serial line encapsulation method for transmitting datagrams over
asynchronous serial point-to-point links. If linking the router to a computer, each end must know the other's
IP address.
3. PPP_SYN – This serial line encapsulation provides a method for transmitting datagrams over synchronous
serial point-to-point links. Unlike the SLIP protocol, PPP can determine the IP address configuration
automatically.
The mandatory first two characters of an AT command string.
Initializes the modem to its default settings.
Displays the established connection speed to the dial-in user (e.g. Connection established at 56.6
kps).
19
DI-1162/DI-1162M Remote Access Router