Table of Contents
Advertisement
VPN-L2TP Settin
gs
The Layer 2 Tunneling Protocol (L2TP) is another method of establish
secure tunnel between your DFL-600 and a remote gateway. The L2TP
Status page allows you to enable or disable L2TP o
L2TP Pass Through
L2TP Status
Starting IP Address
Ending IP Address
Click Enable to allow L2TP packets to pass
through the router to the destination computer o
your LAN. When IPSec Pass-through is
enabled, the DFL-600 will allow L2TP packets
to reach their destination computer on your
LAN.
L2TP can be Enabled or Disabled by clicking
the appropriate click-box and the clicking the
Apply.
This allows you to specify a range of IP
addresses for servers on your network that can
use the L2TP protocol. If you have only one IP
address
, enter this address in both the Starting
IP Address and Ending IP Address
This allows you to specify a range of IP
addresses for servers on your network that can
use the L2TP protocol. If you have only one IP
address, enter this address in both the
IP Address and Ending IP Address
ing a
n the DFL-600.
fields.
Starting
fields.
n
Advertisement
Table of Contents
