Table of Contents
Advertisement
VPN-PPTP Settings
The Point-to-Point Tunneli
establishing a secure tunne
The PPTP Settings page allows you to enable or disable PPTP on the DFL-
600.
PPTP Pass Through
PPTP Status
Starting IP Address
Ending IP Address
ng Protocol (PPTP) is another method of
l between the DFL-600 and a remote gateway.
Click Enable to allow PPTP packets to pass
through the router to the destin
y
our LAN. When IPSec Pass-through is
enabled, the DFL-600 will allow PPT
to reach their destination computer on your
LAN.
PPTP can be Enabled or Disabled by clicking
the appropriate click-box and the clicking the
Apply.
This allows you to s
pecify a range of IP
a
ddresses for clients on your network that can
use the PPTP protocol. If you have only one I
address, enter this address in both the Starti
IP Address and Ending IP Address fie
T
his allows you to specify a range of IP
addresses for clients on your network
use the PPTP protocol. If you have only one IP
address,
enter this address in both the Starting
IP Address and Ending IP Address fields.
ation computer on
P packets
P
ng
lds.
that can
Advertisement
Table of Contents
