Your Network - D-Link DI-624 Quick Installation Manual

Connecting The DI-624 Wireless Router To

Your Network

A. First, connect the power adapter to the receptor at the back panel of the
DI-624 and then plug the other end of the power adapter to a wall outlet or power
strip. The Power LED will turn ON to indicate proper operation.
B. 1. Power off your Cable or DSL modem; some devices may not have a on/off
switch and will require you to unplug the power adapter. Now, the DI-624 should
be powered on and the Cable / DSL modem should be turned off.
2. Cable / DSL modem
Connect an Ethernet cable to the Ethernet jack located on the Cable / DSL
modem. After the Ethernet cable is securely connected, power on the Cable /
DSL modem by turning on the unit or plugging in the power adapter.
3. Cable / DSL modem
Insert the other end of the Ethernet cable to the WAN PORT on the back panel
of the DI-624. The WAN LED light will illuminate to indicate proper connection. If
the WAN LED is not illuminated, please go back to step B1 and repeat the
instructions.
C. Insert an Ethernet cable to
available Ethernet port on the network adapter in the computer you will use to
configure the DI-624. The LED light for LAN Port 1 will illuminate to indicate
proper connection. (Note: The LAN Ports on the DI-624 are Auto-MDI/MDIX.
Meaning you can use a straight-through or crossover Ethernet cable to the LAN
Ports.)
D. Computers equipped with 802.11g wireless adapters will be able to connect to
the DI-624. The DWL-G650 AirPlus Xtreme G Wireless Cardbus Adapter and the
DWL-G520 AirPlus Xtreme G Wireless PCI Adapter will be able to connect out
of the box with the router using their default wireless settings.
D. Antennas
Used to
wirelessly
connect to
802.11g or
802.11b
adapters.
Reset Button
Pressing this button restores the Router to its original
factory default settings.
(Power Off) – DI-624
(Power On) – DI-624
LAN port 1 on the back panel of the
C. LAN PORTS
These are the
connections for Ethernet
cables to Ethernet
enabled computers.
2
(Power On)
(Power On)
B. WAN PORT
This is for the connection
of an Ethernet cable to the
Cable or DSL modem
A. Receptor for
Power Adapter.
DI-624 and an