Table of Contents
Related Manuals for D-Link DI-624S
Summary of Contents for D-Link DI-624S
- Page 2 System Requirements DI-624S Install Guide D-Link Systems, Inc.
- Page 3 A solid light indicates a proper connection to the power supply. Status LED A blinking light indicates that the DI-624S is functioning properly. WAN LED A solid light indicates a connection on the WAN port. This LED blinks during data transmission.
-
Page 4: Rear Panel
Use these ports to connect USB 2.0 devices. USB 1.1 devices may also be connected but will be limited to USB 1.1 speed. DI-624S Install Guide Reset Button Pressing this button restores the Router to its original factory default settings. - Page 5 DI-624S Install Guide Installation Overview D-Link Systems, Inc.
-
Page 6: Installing The Hardware
Plug the AC adapter into the receptor located on the back panel of the DI-624S. Plug the other end of the AC adapter into a power strip or wall outlet. The Power LED on the DI-624S will turn ON to indicate proper operation. DI-624S Install Guide... - Page 7 (C) Cable/DSL modem (Power ON) - DI-624S (Power ON) Insert the other end of the Ethernet cable into the WAN PORT on the back panel of the DI-624S. The WAN LED light will illuminate to indicate proper connection. If the WAN LED is not illuminated, please go back to STEP (3-A) and repeat the instructions.
-
Page 8: Using The Setup Wizard
Return key. The logon pop-up screen will appear. Type ”admin” for the username and leave the password blank. Click Once you have logged in, the Home screen will appear. Click Run Wizard DI-624S Install Guide admin D-Link Systems, Inc. - Page 9 DI-624S Install Guide You will see the following screens. Click Next Setup your new password. You have the option to establish a password. Click Next Choose your time zone from the drop down list. Click Next D-Link Systems, Inc. The Setup Wizard (continued)
- Page 10 Enter the IP address information originally provided to you by your ISP. You will need to complete all the required fields. Click Next Please continue to Wireless Setup on page 12 DI-624S Install Guide D-Link Systems, Inc.
- Page 11 DI-624S Install Guide If your ISP requires PPPoE (Point-to- Point Protocol over Ethernet), and you have selected this option, then this screen will appear: (Used mainly for DSL Internet Service.) Enter the username and password provided to you by your ISP.
-
Page 12: Wireless Setup
Click Next If you wish to use encryption for your 802.11g network, the DI-624S is capable of two levels of wireless encryption - 64-bit and 128-bit. By default WEP encryption is disabled. You can change the encr yption settings for more secure wireless communication. -
Page 13: Test Internet Connection
DI-624S Install Guide Click Restart Test Internet Connection To test your Internet connection open a Web browser (i.e., Internet Explorer or Netscape Navigator), and then link to your favorite Web site. For additional information, refer to the manual. For additional settings, please refer to the Advanced, Tools, and Status Tabs in the Web Management interface.