If the package has suffered rough handling, bumps or damage (visible or concealed), please note it on the bill of lading before accepting the delivery and contact Omcan within 24 hours, so we may initiate a claim with the carrier. A detailed report on the extent of the damage caused to the machine must be filled out within three days, from the delivery date shown in the shipping documents.
Si el paquete ha sufrido un manejo de poco cuidado, golpes o daños (visible o oculto) por favor anote en la factura antes de aceptar la entrega y contacte Omcan dentro de las 24 horas, de modo que podamos iniciar una reclamación con la compañia.
Page 5
Safety and Warranty IMPORTANT IN THE EVENT A GAS ODOR IS DETECTED, SHUT DOWN UNITS AT THE MAIN SHUTOFF VALVE AND CONTACT THE LOCAL GAS COMPANY OR GAS SUPPLIER FOR SERVICE. FOR YOUR SAFETY DO NOT STORE OR USE GASOLINE OR OTHER FLAMMABLE VAPORS OR LIQUIDS IN THE VICINITY OF THIS OR ANY OTHER APPLIANCE.
Page 6
Safety and Warranty Within the warranty period, contact Omcan Inc. at 1-800-465-0234 to schedule a drop off to either an Omcan authorized service depot in the area, or to an Omcan Service warehouse to repair the equipment. Unauthorized maintenance will void the warranty. Warranty covers electrical and part failures, not improper use.
Technical Specifications Model CE-CN-0125 CE-CN-0170 Item Number 49101 49102 Gas Type Natural Gas 23.6 x 36.6 x 13” 29.5 x 36.6 x 13” Fry Pot Dimensions 599 x 930 x 330mm 749 x 930 x 330mm Exterior Material Stainless Steel Front / Galvanized Sides...
Installation UNPACKING This fryer was carefully inspected before leaving the factory. Upon acceptance of the shipment, the transportation company assumes full responsibility for safe delivery. Immediately after unpacking the fryer, check for possible shipping damage. If the fryer is damaged, save the packaging material and contact the carrier immediately.
Page 9
Installation FLUE CONNECTION Make the flue connection as follows: • Comply with Vapor Removal from Cooking Equipment, ANSI-NFPA Standard #96 (latest edition), available from the National Fire Protection Association, Batterymarch Park, Quincy, MA 02269. • Locate the fryer under a hood with adequate connection to an exhaust duct. The hood must extend 6” (15 cm) beyond fryer on both sides.
Installation FRYERS WITH CASTERS Separate instructions for installing casters are included with the casters: • The installation shall be made with a connector that complies with the Standard for Connectors for Movable Gas Appliances, ANSI Z21.69, CAN/CGA-6.16, and a quick-disconnect device that complies with the Standard for Quick-Disconnect Devices for Use with Gas Fuel, ANSI z21.41 CSA 6.9 or Quick-Disconnect Devices for Use with Gas Fuel.
Page 11
Operation 300 F (149 C). If an overheating situation persists, contact your local authorized service office. BEFORE FIRST USE CLEANING New units are wiped down at the factory to remove any visible signs of dirt, oil, grease, etc. remaining from the manufacturing process.
Page 12
Operation • After the set temperature has been reached, the thermostat shuts off the gas flow to burners. • The pilot remains lit. The burners will cycle on and off, maintaining the set temperature. TURNING OFF THE FRYER 1. Turn the thermostat OFF. 2.
Maintenance DRAINING THE OIL WARNING Hot oil and hot parts can cause burns. Use care when operating, cleaning, and servicing the fryer. 1. Turn the thermostat knob to the OFF position. 2. Insert the drain extension into the drain valve. Tighten only hand tight. 3.
Page 14
Maintenance 2. Once the shortening has been drained, flush out scraps and sediment using the cleaning brush. 3. Close the drain valve and fill tank water. Use a low foaming cleaner/degreaser to clean the fry tank. Follow the instructions on the side of the package. NOTICE Do not use chlorine or sulfate/sulfide cleaners.
Troubleshooting Problem Probable Cause No heat. Thermostat dial not turned on. Pilot not lit. Gas supply not turned on. Wire connections loose (call service). Wires connections need cleaning (call service). Thermopile (call service). Insufficient or too much heat. Thermostat dial not set to desired temperature. High limit tripped (call service).
Parts Breakdown Model CE-CN-0125 49101 Model CE-CN-0170 49102...
Page 17
Parts Breakdown Model CE-CN-0125 49101 Model CE-CN-0170 49102 Item No. Description Position Item No. Description Position Item No. Description Position Housing Assembly for 49101, Drain Valve 1(14)″ for 49101, Pilot Connector for 49101, 49102 49102 49102 Front Decoration Plate for 49101, Pilot Corrugated Pipe Ф6.35 for...
Warranty Registration Thank you for purchasing an Omcan product. To register your warranty for this product, complete the information below, tear off the card at the perforation and then send to the address specified below. You can also register online by visiting: Merci d’avoir acheté...
Page 20
à plus de 6500 produits provenant du monde entier. Desde 1951 Omcan ha crecido hasta convertirse en un líder en la distribución de equipos y suministros de alimentos en América del Norte industria de servicios. Nuestro éxito en estos años se puede atribuir a nuestro compromiso de fortalecer y desarrollar nuevas relaciones...
Need help?
Do you have a question about the CE-CN-0125 and is the answer not in the manual?
Questions and answers