Yamaha 01V96i Owner's Manual page 17

3
STEREO OUT connectors L/R
Female XLR plug
These balanced XLR-3-32-type connectors output
the Stereo Out signals. The nominal signal level is
+4 dB.
Digital I/O Section
1 2
1
WORD CLOCK OUT connector
This BNC connector outputs a wordclock signal
from the 01V96i to a connected external device.
2
WORD CLOCK IN connector
This BNC connector inputs a wordclock signal
from a connected external device to the 01V96i.
3
ADAT IN/OUT connectors
These optical connectors input and output ADAT
digital audio signals.
4
2TR OUT DIGITAL COAXIAL
This RCA phono connector outputs consumer for-
mat (IEC 60958) digital audio. The connector is
typically used to connect the digital stereo input
(consumer format) of a DAT recorder, MD
recorder, or CD recorder.
5
2TR IN DIGITAL COAXIAL
This RCA phono connector accepts consumer for-
mat (IEC 60958) digital audio. The connector is
typically used to connect the digital stereo output
(consumer format) of a DAT recorder, MD
recorder, or CD recorder.
2 (hot)
3 (cold)
1 (ground)
3 4 5
MIDI/USB Section
1
1
MIDI IN/THRU/OUT ports
These standard MIDI IN, OUT and THRU ports
enable you to connect the 01V96i to other MIDI
equipment.
2
TO HOST USB port
This USB port enables you to connect a computer
equipped with a USB 2.0 port.
Note when using the TO HOST USB port
When connecting the 01V96i to a computer via the
TO HOST USB port, please take the following mea-
sures.
If you fail to take these measures, your computer or
the 01V96i may stop operating (hang up), or data
may be lost or damaged. If the computer or console
stops operating, turn the power off and on again, and
reboot the computer.
• Before connecting the TO HOST USB port to
your computer, disable the power conservation
(suspend/sleep/standby/hibernate) settings of
your computer.
• Connect the TO HOST USB port to the computer
before you power-on the console.
• Before powering the console on/off or connect-
ing/disconnecting the USB cable, you must do the
following.
- Close all applications.
- Make sure that the console is not transmitting
data. (The console also transmits data when
you operate its buttons or move its faders.)
• Leave an interval of at least six seconds between
powering the console off and on, or between dis-
connecting and reconnecting the USB cable.
17
Rear Panel
2
01V96i—Owner's Manual