Disc Loading/Unloading - Pioneer CMX-3000 Operating Instructions Manual

B Connecting the CMX-3000 to stereo amplifiers (when not using a DJ mixer)
Stereo
amplifier
Connect audio cable to CD or AUX input jacks.
(Do not connect to PHONO input jacks.)
INPUT
L
R
C Connecting the CMX-3000 to devices with digital input jacks
CD recorder or other device with
digital input amplifier
DIGITAL INPUT
OPTICAL COAXIAL
¶ When using the digital output jacks, the DIGITAL MODE switch must be set to 'ON'.
Note:
Turning the DIGITAL MODE switch 'ON' causes all DJ features (i.e., CUE, LOOP, RELOOP, TEMPO CONTROL, MASTER
TEMPO, increase/reduce speed by the jog dial or HOT CUE) to be disabled. Also note that when using digital output pausing
results not in a start playback pause but in a silent pause instead.
4. Connecting the power cord
When all connections have been made, connect the power cord to the AC inlet on the rear panel of the player and connect the power
plug to an AC wall outlet or to a power receptacle on the rear panel of the amplifier.

DISC LOADING/UNLOADING

Label surface up
Insert straight
1. Press POWER switch on front of player to turn power
on.
Do not force a disc into the unit when the POWER switch is set
to OFF as this may damage the disc and the unit.
2. Insert a disc.
¶ Hold the disc with label surface upwards, and insert into the
front panel disc insertion slot .
¶ When playing an 3 inch/8 cm disc, place the disc in a
commercially available CD adapter before inserting in the
insertion slot.
CD
CMX-3000 audio cable
Digital signal
cable
POWER switch
¶ Each insertion slot can only accommodate one disc at a time.
Never attempt to load more than one disc at the same time,
or attempt to load a second disc when one disc has already
been loaded.
¶ When loading a disc, do not placing any twisting force on the
disc, or try to force the disc into the slot. Also, do not attempt
to interrupt or defeat the motion of the disc when the player
begins to draw a disc into the slot or to eject a disc, since
damage to the disc or player could occur.
3. During playback, press the PLAY/PAUSE button
(38) or if a cue point has been specified press the
CUE button to back-cue before pressing the EJECT
button (0) to eject a disc
¶ When the EJECT button is pressed, disc rotation stops and
the disc is ejected from the loading slot.
¶ If the disc fails to be ejected when the EJECT button is
pressed, the accessory forced eject pin can be inserted into
the front-panel's forced eject hole to eject the disc. (see p. 5)
CAUTION:
Do not attempt to press a disc back into the slot when the EJECT
indicator appears. Pressing a disc back into the slot while the
EJECT indicator appears may cause the player to stop. In this case,
press the EJECT button again and wait until the EJECT indicator
goes out before reinserting the disc.
Read before use (Connections)
Player
Player
<DRB1307>
11