Connections - Pioneer CMX-3000 Operating Instructions Manual

Read before use

CONNECTIONS

Before connecting or disconnecting any cables, be sure to first turn off the power switch and remove the power cord from its
socket. The CD player may be damaged if cables are connected when the power is on.
1. Connecting the player to the remote control unit
First connect the CD player to the remote control unit.
Specialized
connection cable
2. Connecting the system to a DJ mixer (DJM-300, DJM-500, or DJM-600)
(connecting audio output and control jack cables)
Using the audio cables provided with your CMX-3000 CD player system, insert the white plugs into the left (L) jacks and the red plugs
into the right (R) jacks. Note that it is also possible to use the CMX-3000 control cord to control the CMX-3000 from a mixer to make
it possible to use fader startup or back cueing. (This does not apply, however, during relay playback.)
Player
¶ When connecting to a DJM-300, DJM-500 or DJM-600 mixer, use the CMX-3000 audio cables to connect CD1 to A PLAYER and
CD2 to B PLAYER as indicated in the diagram above.
3. Connecting the CMX-3000 to other devices
A Connecting the CMX-3000 to other mixers
To connect the CMX-3000 to other mixers, connect the CMX-3000 AUDIO OUT jacks to the line input jacks or AUX jacks of the mixer.
(Do not connect to PHONO jacks, as doing so would result in the sound being distorted and in being unable to obtain normal playback
quality.)
10
<DRB1307>
Remote control unit
Player
CMX-3000
audio
cable
L L
PHONO LINE PHONO LINE
R R
PHONO2 LINE3 CONTROL PHONO1 LINE1
/LINE4 /LINE2
CH - 2 CH - 1
CMX-3000
control cord
CONTROL
CMX-3000
control
cord
CMX-3000
audio cable