Table of Contents
Advertisement
No picture &
No sound
Picture OK &
No sound
The remote control
doesn`s work
Picture appears slowly
after switching on
No or poor color
or poor picture
Horizontal/vertical bars
or picture shaking
No output from one of
the speakers
Unusual sound from
inside the TV
30 Plasma TV
Check whether the TV is turned on from both front button and t
he back switch.
Is the power cord inserted into wall power outlet?
Test the wall power outlet, plug another product`s power cord into the
outlet where the TV`s power cord was plugged in.
Press the VOL+ button.
Sound muted? Press MUTE button.
Check to see if there is any object between the TV and the remote
control causing obstruction.
Are batteries installed with correct polarity (+ to +, - to -)?(Refer to p.8)
Correct remote operating mode set: VCR etc.?
Install new batteries. (Refer to p.8)
This is normal, the image is muted during the display startup process. Please
contact your service center, if the picture has not appeared after five minutes.
Select
Color Temperature
Keep a sufficient distance between the TV and the VCR.
Activate any function to restore the brightness of the picture.
Check for local interference such as an electrical appliance or power tool.
Adjust
in the
Balance
SOU.
A change in ambient humidity or temperature may result in an unusual noise
when the plasma display is turned on or off and does not indicate a fault with it..
in the ADJ menu and press the VOL+/- button.
menu. (Refer to p.21)
Advertisement
Table of Contents
