Installing 16-Bit Netware Client For Dos; Troubleshooting; Troubleshooting The Hardware Installation; Troubleshooting The Software Installation - D-Link DFE-660TX User Manual

10/100 ethernet pc card for cardbus
Table of Contents

Advertisement

A

Troubleshooting

Troubleshooting the
Installation
Hardware
If you experience any problems with the hardware installation, first
ascertain that all network cable connections are firm, that the proper
grade of cable is used for the network connection, and that the cable
makeup is correct (straight –– without un-needed crossovers in the
connector wiring). Check that the supporting hub is power-on and
operating normally, and that the hub is properly qualified (under
10Base-T and/or 100Base-TX standards).

Troubleshooting the Software Installation

You Get the "DFE-660TX PC Card Not Detected" Error
You are running Installation Director, and in the Main Menu you
have selected
Quick Install 16-bit Driver for Dos Netware Client
The Quick Install run is then interrupted by an error message which
DFE-660TX
says that the
PC Card is not detected by the system.
You have followed the instruction given by the error message, to
repeat Step 1 of the Hardware Installation procedure given at the
beginning of Chapter 2 of the User's Guide. And you have then re-
run Installation Director. And the same error message has come up.

Advertisement

Table of Contents
loading

Table of Contents