Installing The Gigabit Ethernet Card - D-Link DGE-500T User Manual

Installing the Gigabit Ethernet Card

Shut down the computer, unplug its power cord, and remove
1.
the chassis cover.
2. Insert the contact edge of the Gigabit Ethernet card into the
connector of any available PCI Bus Master expansion slot.
Press the card firmly into the connector such that the card's
contacts are fully seated in the connector.
3. Install the bracket screw, which secures the card to the
computer chassis.
4. Replace the computer's chassis cover.
5. Reconnect the computer's power cord, and switch computer
power on. If the BIOS section of your computer's boot
program is Plug-and-Play compliant, then at power-up the
BIOS will automatically configure any newly installed the
Gigabit Ethernet Card.
NOTE
: Due to a fault in some Plug-n-Play BIOS programs, it happens
occasionally that a newly installed adapter is assigned an
Interrupt Number which is already assigned to another device.
In such a case, the conflict of Interrupt Number will cause
faults in the behavior of both devices. Then it is necessary to
run the CMOS Setup utility, and manually assign a non-
conflicting Interrupt Number.
6