Hardware Installation - D-Link DFE-660TX User Manual

DFE-660TX Fast Ethernet PC Card User's Guide
In the event that any item is missing, or if you find any mismatch or
damage, promptly contact your dealer for correction.

Hardware Installation

Follow these four steps to install the DFE-660TX:
Step 1 Insert the DFE-660TX
Under the PC Card standard and the corresponding Japanese JEIDA
standard, PC Cards may safely be "hot swapped" –– it is not
necessary to switch the computer's power off before installing or
removing the DFE-660TX, or any other PC Card.
Find/select an open Type II or Type III PC Card slot on your
notebook computer's side or rear panel. Hold the DFE-660TX with
the colorful D-Link splash label upward. Notice that the splash label
features a yellow triangle or "arrow," which points to the front end
of the PC Card. Insert the front end of the PC Card into the CardBus
slot, and slide the PC Card all the way into the slot until it reaches a
firm stop.
NOTE: Many notebook PCs feature a stacked pair of PC Card slots,
logically (but not physically) designated as Slot 1 and Slot 2.
8
Type II or Type III
PC Card slot(s)
D-Link color-splash
label facing up
Hardware Installation