AT&T 1739 User Manual page 5

Operation
Listen to, save & delete messages
• The system automatically saves all incoming messages until you delete
them. You can store approximately 40 minutes of messages, memos and
announcements (up to a maximum of �� messages).
• Before playing each message, the system announces the day and time
the message was received. If Store number is activated, the system
also announces the caller's telephone number (see Store number under
Feature setup on page 3). After playing the last message, the system
announces "End of messages."
• Messages cannot be deleted until they have been reviewed, and deleted
messages cannot be retrieved.
To operate the answering system, follow the instructions below.
Press to
listen to new
messages.
Press during
playback to stop
playback.
If there are no
new messages,
press to listen to
old messages.
Message window
Press to delete the
message currently
playing.
Press and hold in idle
mode to delete all
messages if there are
no new messages.
Press to turn the system on or off.
The light is off when the system
is turned off.
The light is on steadily when
system is turned on with no
new message.
The light flashes when memory
is full. (Delete messages to
make room for new messages.)
The light flashes when there are
new messages.
The light flashes during the
Feature setup process.
Press to repeat the
current message or
press twice to hear
the previous message.
Press during time/day
announcement to repeat
the previous message.
Press and hold to play
recorded messages at
half speed when they
are played.
Press and hold in idle
mode to record a memo.
Press to choose the
setting in feature setup.
4
Press to listen to
the current setup.
Press and hold
to start the setup
process.
Press to adjust
volume. The
system beeps
three times at
the highest or
lowest setting.
Press to listen to
the current time.
Press and hold to
setup the clock.
Press to skip to the
next message.
Press to play back
the announcement.
Press and hold to
play twice as fast
when listening to
recorded messages.
Press and hold in idle
mode to record an
announcement.
Press to choose the
setting in feature
setup.